K-Meleon :: Development

Development : K-Meleon Forum

K-Meleon development related discussions.

Goto: Forum List•Message List•Search•Log In

Your Name:
Subject:

Help information

[quote=JamesD]
@ deadlock

You have found something new.  Well, new to me.  There is an item in EDIT - PREFERENCES - PAGE DISPLAY - GENERAL.  It is called default zoom.  You cannot go as far with page out as you can with page in zoom if you are set at the default of 100.

Also you must use one of the methods which uses the zoom.kmm file in order for the zoom action to be captured.

Try this for a test.  
Open two tabs each with some text showing.  Go to the tab on the right in your tab bar.  Increase the text zoom there two times using "CTRL ALT VK_PLUS". (I am assuming that is the one on the numeric keypad.)  Change the focus to the tab on the left.  Reset the zoom using ALT+SHIFT+0.  Your left tab will zoom out twice or to the minimum default zoom.  Check the text zoom in the statusbar. Shift the focus to the right tab.  It has not changed. Try ALT+SHIFT+0 again.  Nothing will happen.  All the count was used when you were in the left tab.  The count was global because I don't have any way to identify which tab did the zooms. If the zooms had been identified as belonging to the right tab, then nothing should have happened when you were in the left tab and pressed ALT+SHIFT+0.  The right tab's count would have been kept available in case you wanted to reset the right tab.

The whole reset of zooms idea has a major flaw.  There are ways to zoom that do not use zoom.kmm.  If I am wrong in this it is because I don't see the point at which the other methods enter zoom.kmm.[/quote]

K-Meleon forum is powered by Phorum.